Re: <VV> Motor specs

[Joe West]

-----Original Message-----
>>From: UltraMonzaWest@aol.com [mailto:UltraMonzaWest@aol.com]
>>Sent: Wednesday, October 06, 2004 12:47 AM
>>To: virtualvairs@corvair.org
>> Re: <VV> Motor specs
>>
>>In a message dated 10/5/2004 5:34:06 PM Pacific Daylight Time,
>>TAMR3813@att.net writes:
>>
>>>Dose any one have the bore size and recommend connecting rods for a
>>>
>>67
>>
>>>motor. Also can VW pistons and rods fit into the stock motor or
>>>
>>dose it
>>have to
>>
>>>be bored out. Just looking for some info on ways to build more
>>>
>>power out
>>of
>>
>>>a Corvair motor because were drooping it to fully rebuild it and
>>>
>>wondering
>>
>>>how to make more power out if them.
>>>
>>>Drew
>>>Irongrave Customs
>>>
>>************************************************ ***************
>>
>>Go to my website......Tech papers........you'll see a chart with eve
>>possible
>>combo around... http://members.aol.com/patiomatt/
>>
>>It's common to use VW 94mm barrels ...but the work is extensive for
>>clearances as well as boring the cases / heads to accept the larger
>>barrels...
>>Several of our shops do it for a price! $1200 plus......your good
>>heads
>>and
>>cases...you assemble..
>>
>>Vair rods are adequate for all but the highest HP engines....300 hp
>>plus...
>>
>>
>>Matt
>>
>>--__--__--
>>
>>