Joe West
05-09-2005, 08:25 PM
------------------------------
Date: Sun, 31 Oct 1999 10:18:52 -0500
From: David Binnie <D.BINNIE@netcom.ca>
<VV> Looking for some sheet metal
I am ressurecting a 60 coupe that most would not, but being a Monza, I
just cannot junk it. Besides, 60's are so smooth. I am looking for
someone who is scrapping an early coupe, which might have some "dogleg"
areas that are still solid. I need the area in front of the rear wheels
on both sides from the bottom of the car up about 8". I also need the
section under the rear bumper. If anyone has this for sale, please
e-mail me. Thanks
Dave Binnie
------------------------------
End of Virtual Vairs Digest V1 #188
***********************************
majordomo@skiblack.com with "unsubscribe virtualvairs-digest" as the first
::::::::::::::
Date: Sun, 31 Oct 1999 10:18:52 -0500
From: David Binnie <D.BINNIE@netcom.ca>
<VV> Looking for some sheet metal
I am ressurecting a 60 coupe that most would not, but being a Monza, I
just cannot junk it. Besides, 60's are so smooth. I am looking for
someone who is scrapping an early coupe, which might have some "dogleg"
areas that are still solid. I need the area in front of the rear wheels
on both sides from the bottom of the car up about 8". I also need the
section under the rear bumper. If anyone has this for sale, please
e-mail me. Thanks
Dave Binnie
------------------------------
End of Virtual Vairs Digest V1 #188
***********************************
majordomo@skiblack.com with "unsubscribe virtualvairs-digest" as the first
::::::::::::::