Joe West
05-25-2005, 09:25 PM
------------------------------
Date: Wed, 13 Sep 2000 18:36:08 -0400
From: Barneck Doug C TIGTA <Doug.Barneck@tigta.treas.gov>
<VV> ignitor wire slicing
I'm reading up on installing the ignitor in my Corvair. For the 12V
positive wire, it states to cut the resistor wire about and inch from the
connector. Can you only see one end of the resistor wire? Will it be
obvious which one to cut? From there, I solder a piece of 16 gauge wire to
the stub and run it directly to the positive terminal on the coil? Is this
correct?
Douglas C. Barneck
Treasury Inspector General for Tax Administration
doug.barneck@tigta.treas.gov
801-620-6591
Date: Wed, 13 Sep 2000 18:36:08 -0400
From: Barneck Doug C TIGTA <Doug.Barneck@tigta.treas.gov>
<VV> ignitor wire slicing
I'm reading up on installing the ignitor in my Corvair. For the 12V
positive wire, it states to cut the resistor wire about and inch from the
connector. Can you only see one end of the resistor wire? Will it be
obvious which one to cut? From there, I solder a piece of 16 gauge wire to
the stub and run it directly to the positive terminal on the coil? Is this
correct?
Douglas C. Barneck
Treasury Inspector General for Tax Administration
doug.barneck@tigta.treas.gov
801-620-6591